Circuit Equations:Transformer

The application of the voltage law to both primary and secondary circuits of a transformer gives:

The transformer is the most common application of the concept of mutual inductance. In the transformer, the effect of the mutual inductance is to cause the primary ciruit to take more power from the electrical supply in response to an increased load on the secondary. For example, if the load resistance in the secondary is reduced, then the power required will increase, forcing the primary side of the transformer to draw more current to supply the additional need.

Circuit Equations: Transformer

The secondary circuit equation is that of an RL circuit driven by a voltage source: 次级电路方程是受电压源驱动的RL电路的方程： The primary circuit current is given by: 主电路电流由下式给出： Show 显示

Note that the effective impedance of the primary circuit contains not only the coupling of the mutual impedance, but contains terms dependent upon the secondary load resistor R. When R is smaller (greater load) , ZP becomes smaller and more resistive, taking more power from the primary source. 需要注意的是，初级电路的有效阻抗不仅包含互阻抗的耦合，还包含依赖于次级负载电阻R的项。当R较小（负载较大）时，Z_P会减小且更趋于电阻性，从而从初级电源中吸取更多的功率。 For ideal coupling, the mutual inductance becomes 对于理想耦合，互感变为

There is a practical midrange of load resistances for the operation of a transformer. In the example above, you can see that maximum output power is obtained with a load resistance between 15 and 20 ohms. When too heavy a load is drawn from the secondary, the primary coil heats up and the amount of audible "hum" that you hear from the transformer increases. My brother, Edgar Nave, worked in commercial electrical construction and wired many large transformers. He reports incidents when the secondary of a transformer was shorted, and says that the transformer would "squawl" like a wounded beast before it burned up the primary coil.

Circuit Equations:Transformer

The application of the voltage law to both primary and secondary circuits of a transformer gives:

Obtaining the circuit equations requires the simultaneous solution of the primary and secondary circuit equations. That solution is facilitated by using the complex impedance method, presuming a sinusoidal supply voltage with angular frequency ω. Standard AC practice uses rms currents and voltages, and in the complex impedance approach the derivative of current dI/dt = jωI. The primary and secondary loop equations then take the form:

From the secondary circuit equation we can find an expression for the secondary current I_S.

This can be substituted into the primary loop equation:

The last term can be rationalized by multiplying numerator and denominator by

giving

This allows us to separate the real and imaginary parts and place the expression in the form of a standard complex number.

This can be written in the form of a standard AC circuit impedance Z:

where